As usual, it has been a busy semester so far with lots of improvement in my abilities as a designer. Today I am going to take the time to post about a handful of my early projects. The first of which is my Studio 3 cantilever project. The goal of this project was to practice the design project in a very extreme case. Our objective with this project was to suspend a two-pound weight as far from the center of a 6-inch circle and a minimum of 7 inches from the surface of the table. This distance from the center of the base would then be divided by the weight of our model to determine the ratio of distance to weight. This ratio along with the thoroughness which with we executed the process of developing the cantilever would then be used to determine our grade. In our cantilever, we could only use super glue and balsa wood sticks and a single 1-pound counterweight. In the end, after at least five iterations, I was the student with the best ratio! I have attached a picture of my final winning design. It is a simple bridge-like truss with side supports to prevent torsion from the weights. My key development was using a single truss instead of two parallel ones which significantly cut down on weight. My final model weighed only 26 grams and extended 14 inches!